PICOBUCK LED DRIVER **High Current Version** 3 LED Drivers on single P - $26 (N RALEIGH)

PICOBUCK LED DRIVER **High Current Version** AL8860 WITH SCREW TERMINALS 3 LED Drivers on single PCB ThePicoBuck LED Driver is an economical and easy to use driver that will allow you to control and blend three different LEDs on three different channels.
By default, each channel is driven at 360mA; that current can be reduced by either presenting an analog voltage or a PWM signal to the board.
There is also a solderable jumper that can be closed to increase the maximum current to 720mA.
The new voltage regulator also increased the voltage rating on the various components on the board, allowing it to be used up to the full 36V, 1A rating of the AL8860 part.
Three signal inputs are provided for dimming control.
You can use the PWM signal from an Arduino or your favorite microcontroller to dim each channel individually, or you can tie them all to the same PWM for simultaneous dimming.
Dimming can be done by an analog voltage(20%-100% of max current by varying voltage from .
5V-2.
5V) or by PWM(so long as PWM minimum voltage is less than .
4V and maximum voltage is more than 2.
4V) for a full 0-100% range.
A small jumper is provided for each channel to allow you to increase the drive strength from 360mA to 7200mA.
Two mounting holes for 4-40 or M3 screws are provided on either side of the board.